From WikiEngineer

Structural: Aluminum

Aluminum Design Practices (and examples)

A Movie Set Made of Temporary Aluminum Box Truss
Fig. 1: Temporary Aluminum Box Truss used on a movie set

Aluminum is a lightweight metal which strength wise falls somewhere in between wood and steel (wood on average will have an allowable bending stress of 1 ksi, Aluminum is around 10 ksi for welded 6061-T6, and Steel is around 20 ksi for A36). Because of its weight, it is often used in temporary structures or during special events.

One fun fact about aluminum (fun in the sense that it is unlike any other material weve learned of so far, not fun in the sense that it greatly complicates the design) is the fact that once aluminum is welded it has significantly less strength than non-welded aluminum. And yes, Im sure wood would also greatly lose its strength if welded to (a little joke).

Note: The most common aluminum (6061-T6) will lose about 50% of its strength once welded

Aluminum Analysis

How to solve for AL sections using the ADM:

Various AL Structures:

Aluminum is used for a variety of different structural uses including:

AL Properties (english units):

Design Codes:

The 2007 version of the IBC used the 2005 version of the Aluminum Design Manual. Although the ADM has a section on welds, additional information for welding can be found in the AWS D1.2 titled .

Retrieved from
Page last modified on October 20, 2010